Type in the full discussion title or a part of it.
Discussion Title Created date
re-configure Atmel Start project change for different processor device
Hello, In AtmelStudio 7, I have a complicated project made with Atmel start for SAM E70 I like to change to SAM V71. How do I use project ->re-configure for a different...
Wednesday, 4 November 2020 - 16:28
spi_m_sync_set_baudrate sets SPI clock divisor on SAM V71
Hello, I have an Atmel Start project on SAM V71. I put bit rates in spi_m_sync_set_baudrate and was not getting the frequencies I was expecting.   When I tried on the V71,...
Thursday, 22 October 2020 - 21:25
SAM V71 WM8904 running at 24bit 96 ksps instead of 16bit 48ksps
Hello all, The code at https://microchipdeveloper.com/asf:audio-sine-tone-intro#Steps_anchor runs at 16 bit 48 ksps. Does anyone here know why it was done like that? Even over...
Wednesday, 21 October 2020 - 17:22
CMSIS not generated in AtmelStart in AS7, but inside ASF in AS7
  Hello, I use AtmelSudio 7 with SAM V71. I like to use CMSIS DSP libraries. What is the right way to have them autogenerated ??? Or do we just copy the folders from special...
Tuesday, 20 October 2020 - 16:31
How to see which channel made XDMAC_Handler run, xdmac_channel_get_interrupt_status stops execution of XDMAC_Handler
Hello, I put a counter and a gpio_toggle_pin  in void XDMAC_Handler(void) and it is running a lot more frequently than expected. The pin is toggling in MHZ range, while it...
Friday, 9 October 2020 - 21:00
SAM V71 WM8904 SSC ADC sample code
Hello, Would someone share with me some sample code for the WM8904 ADC side? Ideally, I would process one sample at a time. Thanks, Frank
Thursday, 8 October 2020 - 21:09
SAM V71 WM8904 SSC one interrupt per sample, one interrupt per XDMA complete
Hello, I would like to have an interrupt per sample of the SSC. I took the demo code from https://microchipdeveloper.com/asf:audio-sine-tone-intro#Steps_anchor and added ISR...
Wednesday, 29 July 2020 - 21:47
Touch LCD with soft demo for ATSAMV71-XULT
Hello, I am looking for a touch LCD, preferably 800 x 480, that is well supported by Atmel Microchip with full demo software in Atmel Studio if possible for ATSAMV71-XULT.  ...
Friday, 26 June 2020 - 13:58