SAME70 Xplained can't see any signal on USART0 tx pin If it is an example code using USART, then its corresponding definition needs to come automatically.
If doesn't, feel free to add those definitions.
Getting used to ASF is not...
[SOLVED] Problem while Pairing with HC-05 BT Module You can take a look the below mentioned link.
http://www.rhydolabz.com/wiki/?p...
The link is for one of their modules, but it might be helpful in this case.
Monday, 17 October 2016 - 05:20
[SOLVED] Problem while Pairing with HC-05 BT Module As far as I know, HC05 cannot be used for basic Bluetooth in command.
Command mode is just for configuring the HC05 module.
The baud rate for HC05 in command mode is 38400 bps....
Atmel studio 7 issue with extern keyword That is interesting.
I was really looking forward to minimize my main c code and I was running out of time.
Anyway the issue got resolved.
I initialized values in...
Writing bootloader for SAMD21 with SPI flash Am afraid I can't help you with this right now.
But what all findings that you make will be really valuable to me as am expected to create a USB bootloader for SAM E70.
I haven't...
Tuesday, 4 October 2016 - 06:28
can i get utc time from rtc in samd20e As per my knowledge, RTC modules normally do not take in location details. Rather it simple runs the clock from the initial set value.
So, if you really need the RTC to work on...
If it is an example code using USART, then its corresponding definition needs to come automatically. If doesn't, feel free to add those definitions. Getting used to ASF is not...
Good work. Thank you for the support :)
You can take a look the below mentioned link. http://www.rhydolabz.com/wiki/?p... The link is for one of their modules, but it might be helpful in this case.
As far as I know, HC05 cannot be used for basic Bluetooth in command. Command mode is just for configuring the HC05 module. The baud rate for HC05 in command mode is 38400 bps....
Thank you for the valuable advice. I'll definitely take a l'll definitely take a look at that that book.
That is interesting. I was really looking forward to minimize my main c code and I was running out of time. Anyway the issue got resolved. I initialized values in...
Good work.
Am afraid I can't help you with this right now. But what all findings that you make will be really valuable to me as am expected to create a USB bootloader for SAM E70. I haven't...
As per my knowledge, RTC modules normally do not take in location details. Rather it simple runs the clock from the initial set value. So, if you really need the RTC to work on...
Though it was tough initially, i am really getting understand how ASF works. I do have miles to cover, but the bright side is I have started doing some coding using AFS. By now, i...
Thanks a lot...
Thank you guys.
Pages