Unable to program SAM E70 board using SWD I am able to program 3 board with the very same design in here without facing any issues & i have never seen such kind of an error before.
But now at the client side, they are...
What are the PADs that are in the data sheet? Hi,
I was just relying on the example codes to figure out the functionality of sercom pins.
This post seems to bring more of an idea like how things works.
Thanks & Regards,...
ADC/AFEC in SAM E70, HELP!!! Yes,
but the issue seems to be limited to that particular board.
I tried with third same70 board & everything seems to be working good.
Need MQTT code for WINC1500 Hi all,
Am working on a similar kind of program.
Has anybody tried working with MQTT chat example.
Thursday, 19 October 2017 - 04:50
WINC1500 P2P demo project error Hi,
Am trying to get P2P communication up, but the example code only demonstrates only the connectivity, right?
Tuesday, 17 October 2017 - 06:36
ATMEL Studio with SAM E70 Xplained Guys, does anybody know what could have caused my Xplained board to behave like in the below mentioned link.
https://community.atmel.com/foru...
I am able to program 3 board with the very same design in here without facing any issues & i have never seen such kind of an error before. But now at the client side, they are...
Probably i can configure WDT & make it overflow to reboot the system. But other than that, is there any good process like the RSTC in SAME70.
Hi, I was just relying on the example codes to figure out the functionality of sercom pins. This post seems to bring more of an idea like how things works. Thanks & Regards,...
I tired working on TCC_QUICK_START example for samd21 & things in there were pretty much straight forward. one short mode PWM will be a simple solution.
NVIC_SystemReset? Did this work?
Yes, but the issue seems to be limited to that particular board. I tried with third same70 board & everything seems to be working good.
Check conf_board.h & see if SPI has been defined?
Hi all, Am working on a similar kind of program. Has anybody tried working with MQTT chat example.
Hi, Am trying to get P2P communication up, but the example code only demonstrates only the connectivity, right?
Guys, does anybody know what could have caused my Xplained board to behave like in the below mentioned link. https://community.atmel.com/foru...
Also check the transfer formats in the datasheet.
Pages