Post Created date
Entering Bootloader on Atmel SAMG55 Xplained Pro
Hi Moti,   However, more than once I've noticed functional differences in F/W behaviour when it was programmed using the bootloader compared to when it was programmed using...
Monday, 23 May 2016 - 18:46
Entering Bootloader on Atmel SAMG55 Xplained Pro
Sounds good Jerry. Good to here the manual reset works ... and NCHG goes low.   That should only happen because you have a non-CRC'd image in flash. Once you do have a CRC-...
Monday, 23 May 2016 - 18:42
Entering Bootloader on Atmel SAMG55 Xplained Pro
Hi Jerry,   Now that you have GPNVM Bit 1 bit cleared, don't yet proceed to the NRST Toggling Force Bootloader sequence   Just do a simple single HW reset (if you...
Sunday, 22 May 2016 - 19:20
Entering Bootloader on Atmel SAMG55 Xplained Pro
OK, after working with an Atmel FAE, here is how it works. This is specifically for the SAMG55 device.   First and foremost, the NRST Toggling Force Bootloader Sequence will...
Thursday, 19 May 2016 - 18:16
SAMG I2C bootloader
Hi sajingeo,   I am experiencing the same problem ...  See https://community.atmel.com/forum...   Were you able to find a solution to this issue ?  ...
Tuesday, 10 May 2016 - 18:28
Atmel G53 boot loader mode problem
Hi Mark,   Did you ever find a solution for this ?   I am experiencing the same problem   .... https://community.atmel.com/forum...   Thanks,   Martin
Tuesday, 10 May 2016 - 18:21
Entering Bootloader on Atmel SAMG55 Xplained Pro
Anybody out there from Atmel Support who may be able to shed some light on this issue ?   Thanks, Martin
Wednesday, 27 April 2016 - 21:31