Post Created date
WINC1500 with STM32F407
It means your connection are not correct so recheck ur connection by multimeter this code is working for me for for same hardware
Thursday, 28 January 2016 - 12:28
WINC1500 with STM32F407
try this code with same connections
Thursday, 28 January 2016 - 11:55
WINC1500 with STM32F407
VBAT on winc side to 3V
Thursday, 28 January 2016 - 11:25
WINC1500 with STM32F407
ok connect VBAT=3V Also and try then and let me know .  
Thursday, 28 January 2016 - 11:14
WINC1500 with STM32F407
send me your circuit diagram only then i can tell u about error. in main i putted PE3 and PA4 on high level  because i am using discovery kit so PE3 is enable pin...
Thursday, 28 January 2016 - 09:47
WINC1500 with STM32F407
it will wait for response from winc1500 module so if you are using debugging then run it it may take some time.use serial terminal to monitor what is going on.and also please...
Wednesday, 27 January 2016 - 11:59
WINC1500 with STM32F407
ya you are right sorry i get confused b/w 2 codes so now right pins for code that is upload by me is winc Reset =PA1 Chip Select =PA2 IRQN          =PA0...
Wednesday, 27 January 2016 - 11:12
WINC1500 with STM32F407
ohh actually you are reading comments in code those are wrong. so please donot read comments see code i had used these pins that i mention in reply.
Wednesday, 27 January 2016 - 10:35
WINC1500 with STM32F407
winc Reset =PB1 Chip Select =PB2 IRQN          =PB0 SCK           =PB10 Mosi,miso =PC2,PC3 SS        ...
Wednesday, 27 January 2016 - 10:09
WINC1500 with STM32F407
Hello Everyone, Finally i have port the winc1500 code to STM mcu. I have attached the full project made in Keil MDK5 for STM32F407 microcontroller.we Port to any mcu by changing...
Monday, 14 September 2015 - 06:36
WINC1500 with STM32F407
OK Thanks Everyone for your support.i have attached the spi porting guide pdf so please check it.I am going to buy development kit from atmel.After running examples on that i will...
Monday, 8 June 2015 - 06:02
WINC1500 with STM32F407
    Quote: So, while is probably safe to assume that Atmel's meaning of "SPI mode 0" is the same as ST's meaning of "SPI mode 0" - that is not guaranteed...  ...
Wednesday, 3 June 2015 - 09:43

Pages