Post Created date
ADC Attiny44
Which sensor should i use for human speech recognition in my project "voice control home appliances using pic16f877" like sensor detects human commands "fan on", "light on" etc...
Sunday, 8 December 2019 - 07:57
Avr Multitasking problems??
(a).Thanks I thought I would piss someone off by questioning them , well the lcd works means that it's lighted up but doesn't give anything(it gives only a blank screen). For...
Sunday, 8 December 2019 - 00:05
24V 3A ampere motor drive using atmega32 pwm
A few tips:   Depending on your needs, you may want a gate driver, like the fan3100...This can greatly improve your efficiency at higher PWM freqs. If efficiency is not a...
Saturday, 7 December 2019 - 01:48
Avr Multitasking problems??
  You still haven't shown us any code that initialises the LCD. Oh, no worries..believe & it will work
Thursday, 5 December 2019 - 21:56
ATtiny1616 start-up time much to long ---- solved
That's it! Disabling the option "Clear Global Variables at Program Startup" in the C Compiler options leads to approx. 250µs start-up time. Thank you! And you thought you were in...
Thursday, 5 December 2019 - 18:13
Avr Multitasking problems??
as I wasn't expecting to make such an error Well, that is good to know     What specific debugging have you done?  What have you found?  Did you verify...
Thursday, 5 December 2019 - 17:58
ATtiny1616 start-up time much to long ---- solved
  If you are disconnecting the programmer & have set it to a normal configuration, then the pin becomes a reset pin...which can delay the startup. If the programmer is...
Wednesday, 4 December 2019 - 18:42
ATtiny1616 start-up time much to long ---- solved
Since updi is in use, there is no reset pin. Well, it depends on how the testing is being done...If the programmer is disconnected & things set up to a normal config, there...
Wednesday, 4 December 2019 - 07:43
Atmega328 controlling led with usart and pyserial
Your test run is horrible.... pyserial should send a "1" then wait, then send a "0" then wait & repeat everything, say 5 times....do you then see your led blinking...
Tuesday, 3 December 2019 - 21:01
ATtiny1616 start-up time much to long ---- solved
Make sure you don't have a cap on the reset line & do have a solid pull up resistor.  Also, make sure your programmer is disconnected/not touching the reset line. Is...
Tuesday, 3 December 2019 - 16:55
ATMega 48A Programing
you were so busy lost in your lack of sleep, you missed my comment:   If the chip is factory set to use the internal 8 MHz clock & the div 8 is enabled (typical factory...
Tuesday, 3 December 2019 - 10:00
Avoiding the need to reinvent the wheel.......
maybe this (may be over kill) https://www.ebay.com/itm/48V-Chassis-Cabinet-Fan-Speed-Control-Module-12V-24V-Fan-485-Serial-Port-Modbus/283268331315?hash=item41f41bb733:g:...
Tuesday, 3 December 2019 - 08:53

Pages