Post Created date
Need design advice for servo control
Since you mention 20ms I guess you¨re talking about RC servos. Lots of prior threads how to handle many servos with software. Use the "Search" function at top of page.
Thursday, 31 May 2012 - 15:51
Incompatible runtime models
mega103 compatibility fuse often screw up things. Aware that m128 by default have this fuse set to act as m103?
Thursday, 31 May 2012 - 14:21
Incompatible runtime models
Quote:I have a project which I was build successfully on a ATmega64, I have changed my project to use ATmega64, but when I build this I get a linker error Like to rephrase that...
Thursday, 31 May 2012 - 12:03
help to develop project
Was going to suggest that you look at the "Projects" section of this site. And also to have a look at "Tutorials Forum" to get you started. But since you're so lazy that you don't...
Thursday, 31 May 2012 - 11:58
WAS: i apologize to all guys [now: Codevision user comments]
Quote:Ok now, can we please move on with the rest of our lives?+1
Tuesday, 29 May 2012 - 23:26
How to get started with analog electronics?
Neill, That looks a lot like the first circuit drawing I made decades ago. How did you get your hands on that??
Tuesday, 29 May 2012 - 07:41
Atmega32 program as master and Atmega32 program as slave
Quote:If I say I understand fully where to put on the 560 Ohm resistors, Im not 100% correct, but Im sure I will get it right soon. This is one document that might help. You can...
Tuesday, 29 May 2012 - 00:33
Atmega32 program as master and Atmega32 program as slave
You will also need 100nF non_polarized ceramic capacitor close to the MAX485 chip between Vcc and Gnd. And it's quite common to add pull-up and pull-down resistors to + and - on...
Monday, 28 May 2012 - 12:37
I2C PCB Layout - SDA, SCL, and Reset Lines
This is what Philips I2C Spec have to say 17.3 Wiring pattern of the bus lines In general, the wiring must be so chosen that crosstalk and interference to/from the bus lines is...
Friday, 25 May 2012 - 17:21
ATtiny85 minimalist EEPROM temp. logger (AVR-GCC)
Quote:Here are the EEPROM contents after letting it run for half a minute or so:Quote:if any serious failures are imminent? EEPROM is only guaranteed to survive 100.000 writes....
Tuesday, 15 May 2012 - 16:38
Getting strarted with SD/MMC card ?
This is how I initialize SD card. Hope you can translate .asm code + comments to your programming language... ;******************* SD CARD INIT ********************** ;SCK...
Monday, 14 May 2012 - 09:20
Simple Timer using atmega16
Quote:If you have any opportunity to decide whether or not to implement case-sensitivity in any user-interface on any computer system in any language, it is always better to NOT...
Friday, 11 May 2012 - 21:05