Post Created date
question: about time$ variable in bascom
Quote:the fastest way is your help.Problem is that you do not listen to advices given. DO1THL put in quite an effort in your other thread to give you a starting point with a...
Tuesday, 20 December 2011 - 11:30
TIMER1 issue
The purpose of this gadget is to catch, save and display user defined packets in TWI, SPI, RS232, RS485 and serial TTL bus formats. 4 software "channels" are set up by user to...
Friday, 16 December 2011 - 13:44
TIMER1 issue
Thanks for your reply. Actually managed to find the problem yesterday that caused me to miss the first bits in the packet. Was enabling INT2 >after...
Thursday, 15 December 2011 - 10:58
Out of range with ATMEGA8
Quote:In fairness to die-hard ASM programmers, it took AVR C compilers some years to avoid "relative branch out of reach" pop up. Both BRxx and RJMP. Makes me remember the first...
Tuesday, 13 December 2011 - 14:56
Out of range with ATMEGA8
Quote:When you code in C, the compiler takes care of non-trivialities like that.Why spoil all the fun?
Tuesday, 13 December 2011 - 00:20
Out of range with ATMEGA8
Please use code tags to make code more readable. Also if you write every line flush left the code is harder to read. I can see no reason why RJMP should not work with such a small...
Monday, 12 December 2011 - 23:56
hang lcd
I don't understand the coding language you're using. My best advice is that you include in your program some lines that turn on a LED (if you have a pin you're not using). Move...
Monday, 12 December 2011 - 22:20
MSPIM question
Nothing beats some good arguing in this fora when all TV stations just offer crap.
Monday, 12 December 2011 - 22:01
MSPIM question
Yes, but you could just as well use any other relevant pin, but then limit the functionality of /SS pin to not being a low input. Of course, there is no reason not to use /SS pin...
Monday, 12 December 2011 - 21:37
MSPIM question
Quote:It would otherwise be wasted.If the "normal" SPI peripheral is used it would be limited since a low input would make SPI enter Slave mode. However, since OP talk about MSPIM...
Monday, 12 December 2011 - 21:28
pin change interrupts on attiny2313
My posts assumed that the "rc controller"/"transmitter" was not connected at all times to the 2313 or connected but not running.
Monday, 12 December 2011 - 19:21
pin change interrupts on attiny2313
Resistors are very cheap Connect i.e. 10k resistor between each input pin and GND and you're good to go.
Monday, 12 December 2011 - 12:51

Pages