Post Created date
Atmel Lightweight Mesh stack
Hello Alex, Now I am trying to setup Lightweight Mesh with RS-485 (Half Duplex). I am using an RS-485 breakout board to achieve this, but it must be triggered to let it know when...
Friday, 19 April 2013 - 20:39
Atmel Lightweight Mesh stack
Hm, OK. Thank you very much for your patience and help! I may have to see if I can figure out what is causing this. Again, thanks for the help!
Wednesday, 10 April 2013 - 10:15
Atmel Lightweight Mesh stack
Thank you for the speedy replies again! I have tried a few different possibilities, but to no avail. Am I correct in thinking that HAL_UART_RX_FIFO_SIZE in the config applies to...
Wednesday, 10 April 2013 - 06:34
Atmel Lightweight Mesh stack
Hello again Alex! I now have peer2peer successfully running as a wireless UART, but am running into a slight inconvenience. The data seems to transmit in bursts. When...
Wednesday, 10 April 2013 - 05:05
Atmel Lightweight Mesh stack
Thank you very much for the speedy reply Alex! I will have to debug our boards a little more to make sure all components are working as expected, and test it out some more. I...
Monday, 8 April 2013 - 03:36
Atmel Lightweight Mesh stack
Hello Alex, I have a few questions about the LwMesh. I was under the impression that I would be able to just program the boards with the Peer2Peer solution provided, and just...
Monday, 8 April 2013 - 02:20