Type in the full discussion title or a part of it.
Discussion Title Created date
Embedding Version Number in 1st Code Page
Does anyone know how I can create a code page that will link into the top of a GCC project? It only has to be 6 or 8 bytes but I think it needs to go in between the code entery...
Thursday, 18 August 2011 - 21:22
3.3vdc power from 24vac
For many years I've powered my projects with LM1806 or similar regulator, usually running it through a full wave bridge so you can use just about any off the shelf wallwart. I'm...
Wednesday, 3 June 2009 - 23:36
Where to get Plug Screw Terminal Blocks
I have a project where I need Screw Terminal Blocks like here: http://www.modtronix.com/popup_i... I'd like to look at 5mm also. Found a few at digikey but they are very...
Wednesday, 22 April 2009 - 22:27
unetserial TCP/IP internet adapter
Hey I'm releasing my unetserial project with a bsd license. Basically it is a serial to internet converter for dialup and GPRS networks. Full PPP/TCP/IP stack on a MEGA64. Problem...
Wednesday, 7 May 2008 - 19:56
programming a mega48 with stk200 programmer
Anyone know how to do it? I've been using ponyprog, but it doesn't support the mega48, is there any other programming software that supports the old STK200 programmer and the...
Monday, 14 August 2006 - 17:49
Reset/Dragon Interface
How are people designing their Dragon Interface and mixing it with their reset button/filter? Typically I use a Switch and a pullup resistor with a .1uf cap to ground, the docs...
Friday, 28 July 2006 - 21:51
SDIO + AVR board plus some software
I've posted it to my site at: http://www.nchip.com/modules.php... Includes schematic in pdf, schematic and board layout in expresspcb, code for WinAVR GCC that initializes the...
Wednesday, 15 March 2006 - 00:01
8-bit parallel flash/rom
Has anyone interfaced an 8bit parallel flash to an AVR, or can you recommend any suitable flash roms? I don't think the serial flash roms have enough random access bandwidth for...
Friday, 18 February 2005 - 00:23
reading and setting fuses from program code?
Does anyone know if you can read and/or set the fuse bits from software? It would be nice to have your code not run and flash a led or print an error message if the fuses are not...
Tuesday, 7 December 2004 - 17:39
USB master on any AVR devices?
or do you know of any ohter USB master chips? thanx, mycal
Thursday, 24 June 2004 - 19:45
Internet Command PRocessor release Mega128
I've just release V0.6 of the uNetSerial internet processor chip at www.nchip.com. There is a free version that runs on the Mega128 and has been tested with many ISP's dialed up...
Tuesday, 25 November 2003 - 09:33
bootloader with boot.h works with mega128 but not mega64
Anyone know what could be wrong? What is the difference between a bootloader for mega128 and mega64? This one has me stumped. thanx, mycal
Monday, 10 November 2003 - 17:49

Pages