Type in the full discussion title or a part of it.
Discussion Title Created date
PID and motor control by PWM
Hi,   I am having a potentiometer which gives an analog voltage in range of 0-5V. I am considering this POT as throttel input for motor. Requirement is if i change the pot...
Fri. Apr 1, 2016 - 11:07 AM
ATMEGA16L & serial communication
Hi,   I am having following USB-2-Serial converter http://www.bafo.com/products/ada...   I need to establish UART serial communication between ATMEGA16 & this...
Wed. Mar 4, 2015 - 05:18 AM
Power circuit design logic -- suggestion
Hi,   I am designing a board where my AVR Microcontroller is powered by LM7805 regulator & my load requires 3.8 voltage, is powered by following voltage regulator...
Tue. Jan 27, 2015 - 06:07 AM
Monitoring voltage for -- 20ms period
Hi , I have many task to perform in a software. Apart from that one is :--- -> I have to calculate that if input voltage on ADC pin is continuously > 3V for 20 ms , then set a...
Tue. Jan 14, 2014 - 11:03 AM
message filtering at -- software level -- mask & filter
Hi, I have enable my can controller to receive all messages & trying to filtering messages it at software level. I referred following link by http://old.nabble.com/Setting-CAN...
Sat. Dec 1, 2012 - 05:38 PM
water tank -- level control
Hi, I am looking forward to implement PID for water tank level control using Microcontroller. I am facing difficulty to select sensors & components related to it. To measure...
Fri. Oct 5, 2012 - 01:28 PM
AVR CAN bus bootloader
Hi, Is there any other boot-loader using CAN bus for AT90CAN32 based controller which uses less memory. I found one app-note AVR914 for a sample bootloader that operates over CAN...
Fri. Jul 27, 2012 - 06:22 PM
Sleep mode entring decision - At90CAN128 @ 16-MHZ
Hi, At90CAN128 @ 16-MHZ My CAN node will most of the time be not doing much work. Will be right to make CAN node to go sleep when nothing is done :?: Node is doing two work in...
Sat. Jul 7, 2012 - 03:24 AM
Relay specification - question
Hi, I have buyed following relay from OMRON, it is expensive compared to normal hobbey relays. G2R-1-SN-12VDC Coil ratings :-- 10A, 250V AC 10A, 30V DC ia.omron.com/data_pdf/...
Thu. Jul 5, 2012 - 07:39 AM
How does this Commercial dimmer works ?
Hi, Can any one suggest how does this dimmer works. It have four channels & expect 0-10V input to control each channel. What is the logic of 0-10 V control input. How it is...
Fri. Jun 29, 2012 - 12:26 PM
Can Bus --- Circuit layout question
Hi, I am preparing layout for my CAN bus node. I am having one question related to routing track for ground for split termination of 60 ohm, 4.7 nf combination & also ground...
Wed. Jun 27, 2012 - 06:57 AM
reverse phase control dimmer based on Cool MOSFET transisor
Hi, I am looking to make my own --- reverse phase control dimmer based on Cool MOSFET transisor -- i will be using in my Home to control lighting. reverse phase control dimmer...
Sat. Jun 16, 2012 - 09:10 AM

Pages