Discussion Title | Created date |
---|---|
Loading a binary file using AS6 (???) Hi All Older versions of AVR32 studio allowed loading a binary file by specifying an offset (0x80000000). AS6 doesn't look to support binary anymore. Problem is that I have binary... |
Wednesday, 19 September 2012 - 18:15 |
AS6 target - missing target ELF selection Hi All Just linking to a couple of possible improvements for AS6 which have caused some problmes: - target names like "abcd1.3.elf" don't work (one needs to rename the output to "... |
Wednesday, 29 August 2012 - 19:39 |
EVK1105 IPv4/IPv6 Dual-stack on line Hi All I have just release uTaskerV1.4-6 for AVR32 and put an EVK1105 running IPv4/IPv6 dual-stack on-line showing its operation: - To contact the boardover IPv4 the following... |
Monday, 6 August 2012 - 10:03 |
Linking to a specific address using AS6 Hi All If one is using AS6 without an external make file, what is the method to link a project to an address other than the standard start address? Eg. link to 0x80000800 rather... |
Tuesday, 3 July 2012 - 21:07 |
uTasker Boot Loader for AVR32 Hi All The following new video shows the uTasker boot loader operating on the AVR32 EVK1100 board: http://youtu.be/e7JvWodljlc This allows fast and reliable remote SW updates via... |
Monday, 9 January 2012 - 03:23 |
AVR32 FTP Client Hi All The following new video shows a demonstration of embedded FTP client operation in the uTasker project: http://youtu.be/sZOCFLDfGTk It is not shown running on an AVR32 board... |
Monday, 9 January 2012 - 03:18 |
AVR Studio 5 - binary programming and connecting to target Hi All I am using AVR Studio 5 and haven't been able to work out how to do the following operations: 1 - load a binary file using "AVR Programming" In the older environment it was... |
Monday, 9 January 2012 - 03:13 |
External Interrupt 0 on UC3C Hi All I have just started with the EIC in the UC3C after using it previously in the UC3A and UC3B. The previously used devices have a single interrupt group for these (External... |
Saturday, 17 September 2011 - 01:08 |
Can one kill an AT32UC3C0512C with Studio 5? Hi All I have just bought an AT32UC3C-EK (quite expensive and a shame that it doesn't have Ethernet connected, but the reason was for a CAN project). Using Studio 5 I loaded some... |
Friday, 2 September 2011 - 22:33 |
USBB Difficulty Hi All I am working with UC3A and UC3B parts with USBB controller - [USB device mode]. The following effect is consistent (using a new driver and not from framework - the... |
Sunday, 26 June 2011 - 01:00 |
JTAGIDE MkII not working with Studio 5 Hi All I can program the AVR32 (UCA0512) with "avr32program" without any problems, but no chance of doing anything from Studio 5. The following is the error message: Quote:Unable... |
Wednesday, 22 June 2011 - 08:54 |
External make files Hi All Has anyone used an external make file with Studio 5? I had a try by setting a path to such a make file (I didn't study the restrictions listed but wanted to see what it did... |
Saturday, 18 June 2011 - 22:28 |