Post Created date
Hex stuff
Quote:Even if you only use 8 bit frames, it's still only 1 byte Just that it is SOOOO nice to use 9 bits comms with RS485 :-)
Sunday, 27 February 2005 - 07:31
OT: Reflow, MLF, Solder Paste and a home made oven
Has anyone used a heatgun to solder a chip in place? Using solder paste and the gun at low speed so that the chip does't get blown away? ...I soldered my broken water pipe with...
Saturday, 26 February 2005 - 21:50
Hex stuff
Quote:If I want to send the char/int value 255, with ascii the mcu will send 3 8bits and if i send it as a hex "string" it would only be 2 8bits If you use 9 bits comm with your...
Saturday, 26 February 2005 - 21:41
AVR Studio 4.11 Servicepack 1 is ready
Oh well....just checked Sudio 4.11, it's 42Mb...so the service pack is smaller...time to get Broadband I think.
Friday, 25 February 2005 - 06:26
AVR Studio 4.11 Servicepack 1 is ready
The service pack is as big as Studio ??? 26Mb
Friday, 25 February 2005 - 06:24
help wanted!! PLEAASE!
Quote:What is meant be "relative"? Relative to where the PC is currently located. Usually 2k back or forward. JMP is same as GOTO.i.e anywhere in memory...well that's not so easy...
Friday, 25 February 2005 - 05:48
help wanted!! PLEAASE!
Quote:I have worked extensively with Microchip microcontrollers, but a new microcontroller always overwhelms me. Using an AVR instead of a PIC will be good for your hairline in...
Wednesday, 23 February 2005 - 22:11
AVR dice board
Quote:is there any change we can get one ? Maybe they will make it available later on, same as the butterfly.
Saturday, 19 February 2005 - 21:34
AVR dice board
Quote:Can you post a pic? This I gotta see Didn't they invite you? :o
Saturday, 19 February 2005 - 03:41
AVR dice board
There are 5 dies with 7 leds each. When you 'roll' the dice the leds pattern changes. It is obviously using 'Charlieplexing'. I don't really want to measure all the connection...
Friday, 18 February 2005 - 09:47
Touch Switch
I use the Qprox switch through 6 mm perspex. 10mm should be doable also. I'm only using 33nf caps for the 6mm material. Quote:i need control a home light thougt capacitive sensor...
Thursday, 17 February 2005 - 22:20
Can't get very low current consuption on Mega48
Are you measuring the current to the chip itself ? (a series regulator would take up some current) What voltage are you running the chip at?
Thursday, 17 February 2005 - 22:09

Pages