Post Created date
Atmega328P Fast PWM OC1A Problem (again)
Maybe I don't understand but how is #if 1 defined?   You should post a full program that someone may want to try out.
Wednesday, 17 April 2019 - 06:04
ABOUT SSD1306
it is a atmega328p.    so your AVR needs 4096 SRAM bytes because of the reserving of two 1024-byte arrays in main(), along with more housekeeping SRAM memory.
Wednesday, 17 April 2019 - 00:28
Why is _delay_ms_ behave unpredictably ?
Look in the debug folder.
Monday, 15 April 2019 - 06:21
silly question about USB terminal
Maybe something like this? https://sites.google.com/site/co...
Saturday, 13 April 2019 - 03:48
Servo motor datasheet
Would you like fries with that?
Friday, 12 April 2019 - 22:47
MPLAB snap to atmega328pb program and debugWIRE
Not sure why after posting the above, I get the Unable to send eMail, Contact Site Admin messages. We are all getting that and not getting any emails notifications for a bout 2...
Thursday, 11 April 2019 - 20:54
Interfacing ESP8266 with atmega8
Nothing to do with Studio, moving to AVR forum.
Wednesday, 10 April 2019 - 20:51
ATMEL Studio 7 - win7/32 Problem with sub's return
If there is a short on portd pin/s then maybe the processor just freezes because the supply drops internally.   HOWEVER if the code runs with with the inline delay that...
Wednesday, 10 April 2019 - 20:47
ATMEL Studio 7 - win7/32 Problem with sub's return
I have cleaned up your code (removed unnecessary bits) and run it on the STK500 (had to invert the bits for that) and it all works well at 1MHz.   Leds flash at about 300ms...
Wednesday, 10 April 2019 - 03:38
ATMEL Studio 7 - win7/32 Problem with sub's return
What do you have on PORTB? If you have a short circuit between pins or to one of the power supply pins then the power could die and the chip reset when you output state 42 or 50.
Tuesday, 9 April 2019 - 23:13
Atmega32 to Atmega32 comunication through XBee modules
You have to tell us a lot more. Most likely you have the wrong clock for a good baud rate or incorrect baud rate, wrong connections etc.   You should start by having...
Tuesday, 9 April 2019 - 07:03
ATM90E32AS PGA gain registers question?
I was going to lock this thread but then it's not quite the same as the other post.
Saturday, 6 April 2019 - 20:47

Pages