Type:
Compiler/Assembler:
English
|
Mixed PWM Drive Version 1.0
Drive this was done in order to help people who are working with PWM for the first time . |
This Mixed Drive PWM it is a circuit board containing some pots and a display 16 columns by 2 lines,a MOSFET transistor high current and high voltage that is a output PWM to be used many userful function that PWM is reasonable. The board has two generators PWM.
PWM channel 1 generates 1Hz to 500 Hz frequency and phase variation from 0% to 100%, PWM channel 2 generates frequencies 500Hz to 100000Hz(100KHz) and phase variation from 0% to 100%, the second (2) channel is modulated by the first (1) high (4.5Volts approximately).
The control of both PWM generators are done through 4 pots with their functions described below-.
The display shown in real time the changes made in the pots showing the values of the frequency in Hz and phase in percentage
Board circuit has four connectors that
The code is made in C++ Language using Atmel Studio 7.0
(*) Coils that are connected in series or bifilar whose impedances were to be calculated case by case, after using the Drive is best frequency and phase values.
|
Below are some board images |
|
|
|
|
|
Below some image of real board, image of display screen and PWM1(Green) signal and PWM2(Yellow) signal |
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
Electronic Schematics |
|
Português
Mixed PWM Drive Versão 1.0 Este Drive foi feito com o intuito de ajudar pessoas que estão se trabalhando com PWM pela primeira vez. |
Este Drive Mixado de PWM trata-se de uma placa de circuito contendo alguns potenciômetros e um display de 16 Colunas por 2 Linhas, um Transistor Mosfet de alta corrente e alta voltagem , que é a saída de PWM para ser usado controle de Motor, Lampas,Bobinas etc. Esta versão consiste em 2 geradores independentes feito dois PWM do atmega8.
O canal PWM-1 gera frequências de 1 a 500Hz e variação de fase de 0 a 100%, o canal PWM-2 gera frequências de 500 a 100000Hz e variação de fase de 0 a 100%, este segundo(2) canal é modulado pelo primeiro(1) em nível alto (4.5Volts aproximadamente).
O controle de ambos geradores e feito através de 4 potenciômetros com suas funções descritas abaixo.
No Visor é mostrado em tempo real as mudanças feitas nos potenciômetros mostrando os valores das frequências em Hz e das fases em percentual.
A placa de circuito possui 4 conectores que são:
São bobinas que são conectadas em série ou bifilar cujas impedâncias deveram ser calculada caso a caso , após com a utilização do Drive se obter os melhores valores de frequência e fase. |