I have a phenomena that I don't know to resolve.
With the WINC1500 I can connect to all AP's, but not to a LinkSys WAP300N.
The WAP300N is configured 2.4G Mixed (bgn) with securitye WPA/WPA2 mixed mode.
With the smartphone I can connect to the WAP300N without any warnings or error message.
I remarked one anomaly, when I start the app wifi explorer on the smartphone it reclaims that it has no 2.4G network, but the access points are shown any way.
When I power off the WAP300N this message disappears.
I use an Atmel WINC1500 for my project.
The call m2m_wifi_connect(parameters) is disconnected (M2M_WIFI_RESP_CON_STATE_CHANGED) with the error 1 (can not scan)
The connection parameters are the ssid, psk with auth type WPA and CH_ALL.
The hardware and firmware information of the Atmel Modul is.
Chip ID 1503a0
Firmware ver : 19.5.4 Svnrev 15567
Firmware Build Oct 4 2017 Time 14:59:09
Firmware Min driver ver : 19.3.0
Driver ver: 19.5.4
The problem comes from the LinkSys. I don't know what it is and could not find any information about it.
I would appreciate if someone could help me.
1. What may be the base of the problem.
2 A way to get connected after the disconnect. (sane as the smartphone)