SAM E70 External Flash interface

Log in or register to post comments
Go To Last Post
5 posts / 0 new
Author
Message
Harikrishnan911
Harikrishnan911's picture
Level: Hangaround
Joined: Fri. Sep 9, 2016
Posts: 219 View posts
Location: Kerala, India
#1
Posted by Harikrishnan911: Wed. Feb 8, 2017 - 08:53 AM
  • 1
  • 2
  • 3
  • 4
  • 5
Total votes: 0

Hi Guys,

Has anybody interfaced external flash IC using Atmel SAM E70 microcontroller?

Any with experience on these, please guide me on the right track to interface External Flash.

I was planing to use the SPI interface onboard SAM E70 to communicate with N25Q032A flash IC.

Silly beans are always silly
:)

Tags:

Atmel SMART ARM-based MCUs and MPUs, Atmel Cortex-M MCUs
Top
Harikrishnan911
Harikrishnan911's picture
Level: Hangaround
Joined: Fri. Sep 9, 2016
Posts: 219 View posts
Location: Kerala, India
Posted by Harikrishnan911: Wed. Feb 8, 2017 - 09:11 AM
  • 1
  • 2
  • 3
  • 4
  • 5
Total votes: 0

In SAM E70 Datasheet, page 41, section 9. Product mapping, I could see QSPI MEM defined from 0x80000000 to 0xA0000000.

Does it mean that the flash chip interface via QSPI can be accessed by reading this location?

Maybe I am wrong, but am just asking.

Silly beans are always silly
:)

Top
Harikrishnan911
Harikrishnan911's picture
Level: Hangaround
Joined: Fri. Sep 9, 2016
Posts: 219 View posts
Location: Kerala, India
Posted by Harikrishnan911: Wed. Feb 8, 2017 - 09:15 AM
  • 1
  • 2
  • 3
  • 4
  • 5
Total votes: 0

Also in datasheet, im section 10.1.5 Flash Memories, the datasheet says that the QSPI interface mapped at address 0x80000000 extends the flash size by adding an external SPI or QSPI flash.

Can anybody help me on this?

Has anybody tried this before?

Silly beans are always silly
:)

Top
Harikrishnan911
Harikrishnan911's picture
Level: Hangaround
Joined: Fri. Sep 9, 2016
Posts: 219 View posts
Location: Kerala, India
Posted by Harikrishnan911: Wed. Feb 8, 2017 - 12:10 PM
  • 1
  • 2
  • 3
  • 4
  • 5
Total votes: 0

This post is same as

https://community.atmel.com/foru...

Silly beans are always silly
:)

Top
regjoe
regjoe's picture
Level: Hangaround
Joined: Fri. Jul 22, 2016
Posts: 179 View posts
Location: Aalen
Posted by regjoe: Fri. Feb 10, 2017 - 06:52 PM
  • 1
  • 2
  • 3
  • 4
  • 5
Total votes: 1

I'm using S25FL127S SPI Flash memory. The MPU cannot run code directly from SPI flash. But as far as I understand the E70 datasheet this should be possible using QSPI flash but there are some things to know.

Maybe this Atmel document can answer your question:

http://www.atmel.com/Images/Atme...

 

 

SAME newbie

Top