SAM D20 Explained how to get Qtouch Anaylzer data

Go To Last Post
4 posts / 0 new
Author
Message
#1
  • 1
  • 2
  • 3
  • 4
  • 5
Total votes: 0

Hi

 

I'm not able to get any analyzer data to evaluate different panels on QT1 and later tune my own user panel.

I have got SAM D20 Pro with mutual and self QT1 up and running, I can configure and change qtouch settings in Atmel start project in Qtouch_Library and QTouch Configurator.

I did enable Debug Data Streaming with suggested RX PA25 and TX PA24 pins in QTouch Configurator.

However I'm not able to analyze data. Can't connect via Qtouch analyzer nor with Data Visualizer, connections fails, what do i miss?

 

many thanks, Adrian

 

 

Last Edited: Thu. Apr 8, 2021 - 08:47 PM
  • 1
  • 2
  • 3
  • 4
  • 5
Total votes: 0

I'm experiencing the same problems, however I'm using the Atmega328PB Xmini.

 

Have you found success?

  • 1
  • 2
  • 3
  • 4
  • 5
Total votes: 0

I'm having the same issue with the SAMD10 Xplained Mini in Microchip Studio. I downloaded the QTouch example project from Atmel START. When I open the Data Visualizer tool the mEDBG COM port appears and I select the datastreamer folder, but when I click connect it fails to find the right baud rate and says "Protocol not detected on COMX." The self-cap pad and LED are functioning correctly.

 

  • 1
  • 2
  • 3
  • 4
  • 5
Total votes: 0

Be awesome and keep to your other thread. As this is and older thread I'll lock it.

John Samperi

Ampertronics Pty. Ltd.

https://www.ampertronics.com.au

* Electronic Design * Custom Products * Contract Assembly

Topic locked