Programming issue on SAME70

Log in or register to post comments
Go To Last Post
4 posts / 0 new
Author
Message
timhsu
timhsu's picture
Level: New Member
Joined: Mon. Jun 11, 2018
Posts: 2 View posts
#1
Posted by timhsu: Tue. Jun 12, 2018 - 11:11 AM
  • 1
  • 2
  • 3
  • 4
  • 5
Total votes: 0

Hi all

I have an SAME70 Explained evaluation board and I loaded the Getting-Started project from ASF,

but when i start debug , Atmelstudio show "Please select a connected tool and ......"

 

Steps  :

1. Open Atmelstudio 7.0

2. SAME70 Explained evaluation board  connect PC (Debug USB / J900)

3. Download Getting-Started example code

4. Build solution

5. Start Debug

6. Show error

 

 

 

 

 

 

Tags:

Tools, Evaluation and Development Kits (ARM-related)
Top
Kevin_L
Kevin_L's picture
Level: New Member
Joined: Wed. Jun 13, 2018
Posts: 3 View posts
Posted by Kevin_L: Wed. Jun 13, 2018 - 04:05 AM
  • 1
  • 2
  • 3
  • 4
  • 5
Total votes: 0

You must make sure you have connect SAME70 XULT USB debug port to your PC, not USB device port. And you should check if you can find EDBG port in your windows Device Manager.

Best Rds

Top
timhsu
timhsu's picture
Level: New Member
Joined: Mon. Jun 11, 2018
Posts: 2 View posts
Posted by timhsu: Wed. Jun 13, 2018 - 05:34 AM
  • 1
  • 2
  • 3
  • 4
  • 5
Total votes: 0

I can fine EDBG port in my windows Device Manager

 

 

 

Last Edited: Wed. Jun 13, 2018 - 05:35 AM
Top
librachien
librachien's picture
Level: New Member
Joined: Wed. Jun 13, 2018
Posts: 1 View posts
Posted by librachien: Wed. Jun 13, 2018 - 09:50 AM
  • 1
  • 2
  • 3
  • 4
  • 5
Total votes: 0

Please select to correct device(part number) name in above of Tool tab,

the Getting Start project in Studio 7 has select to SAME70Q21 (rev.A).

New EVB is using SAME70Q21B (rev.B).

Top