[please delete] debugging via openocd

Go To Last Post
3 posts / 0 new
Author
Message
#1
  • 1
  • 2
  • 3
  • 4
  • 5
Total votes: 0

Sorry, it was my fault, JTAG was locked. The thread can be deleted. Thank you

This topic has a solution.
Last Edited: Fri. Jun 26, 2020 - 07:42 PM
  • 1
  • 2
  • 3
  • 4
  • 5
Total votes: 0

-

Last Edited: Fri. Jun 26, 2020 - 07:39 PM
This reply has been marked as the solution. 
  • 1
  • 2
  • 3
  • 4
  • 5
Total votes: 0

Crankle437 wrote:
J-link is also not working ... Has anyone an idea? 

Segger have an article on debugging J-Link connection issues:

 

https://wiki.segger.com/J-Link_cannot_connect_to_the_CPU

 

You could also try the Segger J-Link forum:

 

https://forum.segger.com/index.php/Board/3-J-Link-Flasher-related

 

 

Top Tips:

  1. How to properly post source code - see: https://www.avrfreaks.net/comment... - also how to properly include images/pictures
  2. "Garbage" characters on a serial terminal are (almost?) invariably due to wrong baud rate - see: https://learn.sparkfun.com/tutorials/serial-communication
  3. Wrong baud rate is usually due to not running at the speed you thought; check by blinking a LED to see if you get the speed you expected
  4. Difference between a crystal, and a crystal oscillatorhttps://www.avrfreaks.net/comment...
  5. When your question is resolved, mark the solution: https://www.avrfreaks.net/comment...
  6. Beginner's "Getting Started" tips: https://www.avrfreaks.net/comment...