MPU Forums transition to Microchip Forum interface

Go To Last Post
4 posts / 0 new
Author
Message
#1
  • 1
  • 2
  • 3
  • 4
  • 5
Total votes: 0

Dear users,

The MPU related forums and related SW solutions are transitioning to the Microchip Forum interface (including Linux):
https://www.microchip.com/forums/f540.aspx

No user migration is planned so you'll have to re-create a profile to benefit from these new forums.

 

EDIT

 

Note as well that the at91.com website and these the MPU-related Atmel community forums will be put in read-only mode in a few months.
 

EDIT2

 

MPU stands for Microprocessors, chips with ARM Application cores of the type ARM9 or Cortex-A, SAM9 or SAMA5 families.

 

Best regards,
Nicolas

Last Edited: Fri. Jul 16, 2021 - 09:08 PM
  • 1
  • 2
  • 3
  • 4
  • 5
Total votes: 0

 

noglitch wrote:
these (sic)  Atmel community forums

Does that include AVRFreaks ?

 

EDIT

 

and the rest:

 

 

EDIT 2

 

Cross-post: https://www.avrfreaks.net/forum/forums-moving-microchip

 

Top Tips:

  1. How to properly post source code - see: https://www.avrfreaks.net/comment... - also how to properly include images/pictures
  2. "Garbage" characters on a serial terminal are (almost?) invariably due to wrong baud rate - see: https://learn.sparkfun.com/tutorials/serial-communication
  3. Wrong baud rate is usually due to not running at the speed you thought; check by blinking a LED to see if you get the speed you expected
  4. Difference between a crystal, and a crystal oscillatorhttps://www.avrfreaks.net/comment...
  5. When your question is resolved, mark the solution: https://www.avrfreaks.net/comment...
  6. Beginner's "Getting Started" tips: https://www.avrfreaks.net/comment...
Last Edited: Wed. Apr 7, 2021 - 09:02 AM
  • 1
  • 2
  • 3
  • 4
  • 5
Total votes: 0

As written in the announcement, it's for MPUs/Microprocessors/SAM9+SAMA5 chips, so no this announce is not about AVR Freaks.

  • 1
  • 2
  • 3
  • 4
  • 5
Total votes: 0


and also not about MCUs, and the other communities (IoT, Touch) ?

 

The OP said "MCU", but was posted in "Linux" - so are all the OS forums included?

 

 

Will posts be "cherry-picked" from the 'Tools' section ?

 

 

Top Tips:

  1. How to properly post source code - see: https://www.avrfreaks.net/comment... - also how to properly include images/pictures
  2. "Garbage" characters on a serial terminal are (almost?) invariably due to wrong baud rate - see: https://learn.sparkfun.com/tutorials/serial-communication
  3. Wrong baud rate is usually due to not running at the speed you thought; check by blinking a LED to see if you get the speed you expected
  4. Difference between a crystal, and a crystal oscillatorhttps://www.avrfreaks.net/comment...
  5. When your question is resolved, mark the solution: https://www.avrfreaks.net/comment...
  6. Beginner's "Getting Started" tips: https://www.avrfreaks.net/comment...