Lightweight mesh stack setup advice for multiple devices?

1 post / 0 new
  • 1
  • 2
  • 3
  • 4
  • 5
Total votes: 0

Hi All


Till now i have been using the Light weight mesh stack with the ATMEGA1284P and AT86RF233.  I had originally started with the ATMEGA1281 project and modified to get it working on the ATEMGA1284P. I think i also removed unnecessary projects of other devices. 

But now i need to use my application to also work on ATmega128RFA1. I can see all the HAL and phy folders are there. 


I have not yet tried it, but i think i can simply swap the folders in my solution explore and do a SaveAs for projects. This would allow me to use the same application for projects i presume?


Is there anything i must keep in mind when working with ATmega128RFA1 and AT86RF233 to do on the application level?


Thank You