Getting Error:Unexpected Extended Chip Identifier

Go To Last Post
3 posts / 0 new
Author
Message
#1
  • 1
  • 2
  • 3
  • 4
  • 5
Total votes: 0

Hello, 

 

I am new here, I have SAMD21E18A connected to ATMEL-ICE in order to program it. I was able to verify the device information, reading the target voltage ,verifying registers. But the issue is that when I am trying to start debugging it shows me an error. Failed to launch program. ERROR: unexpected chip identifier 0X1001030(expected 0x10010300). Is there any once face the same issue before? How to solve it? 

 

Thanks 

  • 1
  • 2
  • 3
  • 4
  • 5
Total votes: 0

I would contact your chip distributor... That reported chip id is too short to be a SAM part :)

:: Morten

 

(yes, I work for Microchip, yes, I do this in my spare time, now stop sending PMs)

 

The postings on this site are my own and do not represent Microchip’s positions, strategies, or opinions.

  • 1
  • 2
  • 3
  • 4
  • 5
Total votes: 0

Thank you for your response, I was trying to search for an answer online but i could not find. I will try that