Can I program ATWINC1500 to work alone?

Go To Last Post
5 posts / 0 new
Author
Message
#1
  • 1
  • 2
  • 3
  • 4
  • 5
Total votes: 0

Hello, I'm trying to make a IOT system with ATWINC1500

 

I want to make it as smaller as I can, so I want to use ATWINC1500 alone

 

So is it possible to use ATWINC1500 alone after I program it with any programmable MCU or PC?

  • 1
  • 2
  • 3
  • 4
  • 5
Total votes: 0

The ATWINC1500 shall typically be controlled from a host driver running on a host MCU. There are several examples for this available in Atmel Studio->ASF.

 

 

 

  • 1
  • 2
  • 3
  • 4
  • 5
Total votes: 0

Yeah, i think you can do that by loading ATWINC1500 with the ATcommand firmware.. Then it can work alone and you can program/communicate directly using the UART with your Terminal Application in your PC.

  • 1
  • 2
  • 3
  • 4
  • 5
Total votes: 0

Hello avrfreakan,

 

I wasn't aware there is firmware that includes ATcommands. Can you tell me more about this/redirect me. I dont see it on the atmel webpage..

 

Youock

  • 1
  • 2
  • 3
  • 4
  • 5
Total votes: 0

Its not available in Atmel website / ASF.  Check with atmel support, they will provide the firmware, i Guess