ATWINC from client mode to AP mode and back to client mode?

1 post / 0 new
Author
Message
#1
  • 1
  • 2
  • 3
  • 4
  • 5
Total votes: 0

 

Is it basically possible to set the ATWINC1500 module in different modes during operation?

 

  1. From AP mode to Client mode.
    In AP mode, the user can configure the WiFi credentials with a HTTP request. After that, the ATWINC1500 module will connect to the home network in client mode.
  2. From client mode to AP mode and back to client mode.
    The user would like to change the existing credentials. The ATWINC1500 is currently in client mode. Change then to AP mode, receive the new credentials over a HTTP request, then the ATWINC1500 module will connect to the home network in client mode with the new credentials.

 

 

I would try that in an Arduino project. I would take the library WiFi101. what should be considered when changing modes?

Thank you for your feedback