Hi,
I am using ATM90E36A for three phase current measurement.
And getting correct current on all phase.
To get correct current we need to set current gain(in required case)
Do we need any delay(stabilizing time) after setting current gain in ATM90E36A?
Currently I am getting correct current only if I wait for 1.5 seconds after setting current gain.
Scenario:
1. Moving ATM90E36A to normal mode
2. Wait for 50ms
3. Updating registers like current, voltage gain,etc.
4. Wait for 1.5 seconds
5. Reading current values.
6. Moving ATM90E36A to ideal mode
- After 10 seconds again repeating steps 1 to 6
