Way to flash AT91SAM9261 in Microchip Studio?

Go To Last Post
3 posts / 0 new
Author
Message
#1
  • 1
  • 2
  • 3
  • 4
  • 5
Total votes: 0

Hello, I'm investigating how to continue flashing ATSAM9261.  Current state, we use SAM-BA v2.18 using an old programmer to flash the IC, however if that programmer goes kaput we lose the ability to flash these chips.

 

I have an Atmel-ICE-C programmer that I FINALLY got to be detected in Microchip Studio (I guess that's the equivalent to Atmel Studio 7.0?), but Studio doesn't list this MCU as something it can flash.  At the same time, SAM-BA v2.18 doesn't detect Atmel-ICE-C.  So two questions:

 

Is there a way for Studio to support the AT91SAM9261 chip? 

 

Is there a way for SAM-BA to detect the Atmel-ICE-C programmer?

 

Thanks,

Alex

Last Edited: Mon. Oct 11, 2021 - 10:18 PM
  • 1
  • 2
  • 3
  • 4
  • 5
Total votes: 0

awanamak wrote:
ATSAM9261

That's an ARM9 - not an AVR UC3

 

To find the new location of the ARM9 forums, see: https://community.atmel.com/forum/mpu-forums-transition-microchip-forum-interface

Top Tips:

  1. How to properly post source code - see: https://www.avrfreaks.net/comment... - also how to properly include images/pictures
  2. "Garbage" characters on a serial terminal are (almost?) invariably due to wrong baud rate - see: https://learn.sparkfun.com/tutorials/serial-communication
  3. Wrong baud rate is usually due to not running at the speed you thought; check by blinking a LED to see if you get the speed you expected
  4. Difference between a crystal, and a crystal oscillatorhttps://www.avrfreaks.net/comment...
  5. When your question is resolved, mark the solution: https://www.avrfreaks.net/comment...
  6. Beginner's "Getting Started" tips: https://www.avrfreaks.net/comment...
  • 1
  • 2
  • 3
  • 4
  • 5
Total votes: 0

Whoops, my bad.  Will move my post there.  Thank you!