Any stabilizing time required after setting current gain in ATM90E36A

Go To Last Post
2 posts / 0 new
Author
Message
#1
  • 1
  • 2
  • 3
  • 4
  • 5
Total votes: 0

Hi,
I am using ATM90E36A for three phase current measurement.
And getting correct current on all phase.
To get correct current we need to set current gain(in required case)
Do we need any delay(stabilizing time) after setting current gain in ATM90E36A?
Currently I am getting correct current only if I wait for 1.5 seconds after setting current gain.

 

Scenario:

1. Moving ATM90E36A to normal mode 

2. Wait for 50ms

3. Updating registers like current, voltage gain,etc.

4. Wait for 1.5 seconds

5. Reading current values.

6. Moving ATM90E36A to ideal mode

-  After 10 seconds again repeating steps 1 to 6

Last Edited: Wed. May 12, 2021 - 01:57 PM
  • 1
  • 2
  • 3
  • 4
  • 5
Total votes: 0

:: Morten

 

(yes, I work for Microchip, yes, I do this in my spare time, now stop sending PMs)

 

The postings on this site are my own and do not represent Microchip’s positions, strategies, or opinions.

Topic locked