ATWINC3400 XPRO updating firmware

Go To Last Post
4 posts / 0 new
Author
Message
#1
  • 1
  • 2
  • 3
  • 4
  • 5
Total votes: 0

Hi All

 

I am using the SAMD21 Xplained Pro and ATWINC3400 XPRO.

 

I need to update the firmware on the ATWIN3400 as I am getting a miss-match error when creating ASF projects.

 

I have created a serial bridge project using ASG, which is flashed into the SAMD21.

 

I have then created an A Firmware update project using ASF, which I believe has the "samd21_xplained_pro_firmware_update.bat" that I need to run.

 

I am getting the following output as seen the attachment. What am I doing wrong?

 

 

 

 

Attachment(s): 

Thanks

Regards

DJ

  • 1
  • 2
  • 3
  • 4
  • 5
Total votes: 0

Hi All

 

Anyone else had the following errors before:

error(uart_read:61): incomplete read from UART
error(winc_bus_sync_cmd:483): failed to read serial bridge ID query response
error: failed to initialise programming firmware '..\..\programmer_firmware\release3400\programmer_firmware.bin' on device

 

 

Thanks

Regards

DJ

  • 1
  • 2
  • 3
  • 4
  • 5
Total votes: 0

Has anyone been able to successfully update ATWINC3400 with the SAM D21 Xplained board?

Thanks

Regards

DJ

  • 1
  • 2
  • 3
  • 4
  • 5
Total votes: 0

I have successfully done this. The application note is poorly written. I made one or two changes which allowed me to upload certificates. I'm having a few issues on customer board at the moment making slow progress. Can you let me know which steps you have problems with and i may be able to help you