Split from: SAMV71 EVALUATION BOARD

Go To Last Post
2 posts / 0 new
Author
Message
#1
  • 1
  • 2
  • 3
  • 4
  • 5
Total votes: 0

If some functionality is started then  in that i have to count no of seconds so i need to start timer and if functionality completes then i have to stop the timer how to do this in SAMV71 evaluation board.

Ujjwal Tambe

Last Edited: Fri. Jul 6, 2018 - 05:43 PM
  • 1
  • 2
  • 3
  • 4
  • 5
Total votes: 0

Again: New question, New thread!

Top Tips:

  1. How to properly post source code - see: https://www.avrfreaks.net/comment... - also how to properly include images/pictures
  2. "Garbage" characters on a serial terminal are (almost?) invariably due to wrong baud rate - see: https://learn.sparkfun.com/tutorials/serial-communication
  3. Wrong baud rate is usually due to not running at the speed you thought; check by blinking a LED to see if you get the speed you expected
  4. Difference between a crystal, and a crystal oscillatorhttps://www.avrfreaks.net/comment...
  5. When your question is resolved, mark the solution: https://www.avrfreaks.net/comment...
  6. Beginner's "Getting Started" tips: https://www.avrfreaks.net/comment...