ARM STM32F105xx oled display NHD-0420CW-AY3

Go To Last Post
2 posts / 0 new
Author
Message
#1
  • 1
  • 2
  • 3
  • 4
  • 5
Total votes: 0

Hi,

I use a display NHD-0420CW-AY3

Common Driver with Controller : US2066.

I want to use it in I2C but i don't know how to do that.

I took that in arduino :  

Wire.beginTransmission(SLAVE2W);

Wire.write(tx_packet[ix]);

Wire.endTransmission();

but how I can translate this in C ?

Thanks a lot, sorry for my english.

 

Last Edited: Mon. Feb 19, 2018 - 07:25 PM
  • 1
  • 2
  • 3
  • 4
  • 5
Total votes: 0

Since when was STM32 an Atmel product??

 

It's not even Microchip.

Top Tips:

  1. How to properly post source code - see: https://www.avrfreaks.net/comment... - also how to properly include images/pictures
  2. "Garbage" characters on a serial terminal are (almost?) invariably due to wrong baud rate - see: https://learn.sparkfun.com/tutorials/serial-communication
  3. Wrong baud rate is usually due to not running at the speed you thought; check by blinking a LED to see if you get the speed you expected
  4. Difference between a crystal, and a crystal oscillatorhttps://www.avrfreaks.net/comment...
  5. When your question is resolved, mark the solution: https://www.avrfreaks.net/comment...
  6. Beginner's "Getting Started" tips: https://www.avrfreaks.net/comment...
Topic locked