Hi,
I have been trying to upload a program to these fresh custom SAM E70 boards, but unfortunately am getting an error message.
Has any body experienced this before?
Severity: ERROR
ComponentId:20100
StatusCode: 131121
ModuleName: TCF (TCF command:erase failed.)
Could not activate interface, but found DAP with ID 0xbd11477..
This ususally indicated that the device is located or in deep sleep. Try to do a chip erase
Unable to enter programming mode. Verify device selection, interface
settings, target power, security bit, and connections to the target device.
Regards,
Hari