satellite communication

Go To Last Post
2 posts / 0 new
Author
Message
#1
  • 1
  • 2
  • 3
  • 4
  • 5
Total votes: 0

how to configure cc1020 with pc? ,what resistor values should be used? and how to test the cc1020 transmitter signal in spectrum analyzer?

Dash...

  • 1
  • 2
  • 3
  • 4
  • 5
Total votes: 0

Do you mean this: http://www.ti.com/product/cc1020

 

If so, why are you asking on the Atmel forum ?!

 

http://www.ti.com/product/CC1020...

Top Tips:

  1. How to properly post source code - see: https://www.avrfreaks.net/comment... - also how to properly include images/pictures
  2. "Garbage" characters on a serial terminal are (almost?) invariably due to wrong baud rate - see: https://learn.sparkfun.com/tutorials/serial-communication
  3. Wrong baud rate is usually due to not running at the speed you thought; check by blinking a LED to see if you get the speed you expected
  4. Difference between a crystal, and a crystal oscillatorhttps://www.avrfreaks.net/comment...
  5. When your question is resolved, mark the solution: https://www.avrfreaks.net/comment...
  6. Beginner's "Getting Started" tips: https://www.avrfreaks.net/comment...
Last Edited: Sun. Dec 27, 2015 - 05:46 PM