ATZB-X-233-XPRO pin-outs

Go To Last Post
2 posts / 0 new
Author
Message
#1
  • 1
  • 2
  • 3
  • 4
  • 5
Total votes: 0

I'm hoping someone can help me with the ATZB-X-233-XPRO pin-outs. The only manuals I can find are the "ATZB-X-233-XPRO Design Document" and ZibBit Extension User Guide
The ZigBit Extension User Guild is for the ATMega256RFR2 and does not correspond the the xmega xpro device.

The Design documents does not give the MCU pinouts for connectors J1 and J3. (they do have ZigBit id's but I don't know how to map a zigbit id to an mcu port/pin.) I'm assuming there is a hidden document someplace that gives this information.

While Trying to do uart communiction, I finally had to turn on the ports one at a time and try each of the pins for locate the port e uart (the Rx line is on J3 pin 9, the Tx line seems to be on J1 pin 10)
I really don't know what the rest of the pins are connected to, the schematic just shows everything connected to the bus.

thx for any help

Last Edited: Fri. Oct 16, 2015 - 01:47 PM
  • 1
  • 2
  • 3
  • 4
  • 5
Total votes: 0

Ok - I think I've found the pinouts for the xmega ZIBIT extension user guide. Not exactly what I expected so I glossed right over them.